Skip to main content
/

Site Navigation

Your Account

Choose Language

Dispenser Jumper Revision or what?

Hi,

for what is the soldering Jumper on the Dispenser.

Revisison?

Please feetdback.. i don't know what i have to solder together.

Regards

Answered! View the answer I have this problem too

Is this a good question?

Score 0

Comments:

Hi,

Okay so for the Revision Jumper the logically 1 means High and 0 means Low.

Here the List for the next people they looking for.

Rev. 1 : 0 0 1*

Rev. 2 : 0 1 0*

Rev.3 : 0 1 1*

Rev.4 : 1 0 0*

Rev. 5 : 1 0 1*

Rev.6 : 1 1 0*

Rev7. 1 1 1*

by

Add a comment

1 Answer

Chosen Solution

The revision jumpers indicate to the software which revision the board fab is, so that the most up to date software could be used on any board.

The current Dispenser Rev is 3, that means bits 0 and 1 should be pulled high while bit 2 should be grounded.

Was this answer helpful?

Score 1
Add a comment

Add your answer

Nighteagle will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 64